SSP 200 • SIS Configuration and Control 74
Command SIS Command
(Host to Device)
Response
(Device to Host)
Additional Description
Miscellaneous
Reboot system
E1BOOT} Boot1]
Reboot network
E2BOOT} Boot2]
View temperature
E20STAT} X3&]
KEY:
X3&
=
Device temperature (degrees Celsius).
Verbose Mode
Set verbose mode
EX3*CV} VrbX3*]
View verbose mode
ECV} X3*]
NOTE: Verbose mode reverts back to default in the event of a power cycle, disconnect from SSH client, or disconnect from the Ethernet.
KEY:
X3*
= Verbose/response mode: 0 = Clear/none (IP default) 1 = Verbose mode (USB default)
2 = Tagged responses for queries
3 = Verbose mode and tagged responses for queries
SIS over SSH (port 22023)
Enable Echo
E1ECHO} Echo1]
Returns command entered
with response.
Disable Echo
E0ECHO} Echo0]
Returns response only.
View Echo status
EECHO} X5)]
NOTE: Secure Shell (SSH) client connections may add an extra line feed in the final terminator in SIS responses, for example, standard is
X1!]
and SSH is
X1!}]
KEY:
X5)
=
Enable or disable: 0 = Disable 1 = Enable (default)
Serial Host Control Port Mode
Standard Host control
(SIS)
E1*1HSTM} HstmX4)*1]
Device control (no SIS)
E1*2HSTM} HstmX4)*2]
Disable port
E1*0HSTM} HstmX4)*0]
Query port mode
E1HSTM} X4)]
KEY:
X4)
=
Serial Host‑control port mode: 0 = Device Control (no SIS) 1 = Standard Host control (SIS ‑ default)
2 = Disable Port
To Next Page
Loading...
