Installation manual
CNC 8035
ACCESS TO INTERNAL CNC VARIABLES
Other variables
11.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·393·
TIMEG
It shows the timing status of the timer programmed with G4 K in the CNC channel. This variable,
returns the time remaining to end the timing block in hundredths of a second.
RIP
Linear theoretical feedrate resulting from the next loop (in mm/min).
The calculation of the resulting feedrate ignores the rotary axes, slave axes (gantry, coupled and
synchronized) as well as DRO axes.
FBDIF(X-C)
Variable that can be read via CNC, PLC and DNC and permits monitoring the position difference
between the first and second feedback at the oscilloscope with Fagor digital servo system.
If the difference between the two feedback readings exceeds the value set in a.m.p. FBACKDIF
(P100), the CNC will show the relevant error message.
This monitoring depends on the value of a.m.p. FBACKAL (P11).
DISBLO
Variable that indicates the value of thetotal distance programmed in blocks with look-ahead. This
variable is read-only from the CNC and PLC and DNC and may be viewed at the oscilloscope.
Read-and-write variables
TIMER
This variable allows reading or modifying the time, in seconds, indicated by the clock enabled by
the PLC. Possible values 0..4294967295.
The CNC will set this value to 0 when changing the software version or when a checksum error
occurs.
PARTC
The CNC has a part counter whose count increases, in all modes except simulation, every time M30
or M02 is executed and this variable allows its value to be read or modified. This value will be between
0 and 4294967295
The CNC will set this value to 0 when changing the software version or when a checksum error
occurs.
KEY
It allows reading the last accepted keystroke or simulating the CNC keyboard assigning the desired
key code to it.
Monitoring of the difference between the first and second feedbacks is not possible
on CAN axes.
CNCRD (KEY, R110, M10)
Loads register R110 with the value of the last key accepted.
To Next Page
Loading...
