Festo CMMS-ST-C8-7-G2 Assembly And Installation

3. Product description
Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH 29
Necessary I/O triggering during synchronisation via FCT
- DIN4 Output stage enable
- DIN5 Controller enable
- DIN6 Limit switch 0
- DIN7 Limit switch 1
Required I/O triggering during synchronisation via mode switchover with
24 VDC frequency signals
The connection plan shows the switch position in the active operating state.
*) The limit switches are set by default to opener (configuration over FCT)

Festo CMMS-ST-C8-7-G2 Specifications

General

Brand	Festo
Model	CMMS-ST-C8-7-G2
Category	Controller
Language	English