3 Mounting and installation
Festo – MPAL-VI-EN – 2017-07a – English 49
3.3 General installation instructions
Warning
Uncontrolled movements of the connected actuator technology and loose tubing can
cause injury to persons and/or damage to property.
Before carrying out mounting, installation and maintenance work, switch off
the following power sources:
– Compressed air supply
– Operating voltage supply
– Load voltage supply
Electrostatically sensitive components:
Do not touch electrical and electronic components.
Note
Handle all modules and components carefully.
Screws must be placed so that the self-cutting threads can be used.
Only tighten the screws by hand.
Comply with tightening torques.
Secure all of the components without distortion and mechanical tension.
Replace damaged seals.
Keep mounting surfaces clean and dry.
To Next Page
