Festo MPAL-VI - Modification

7 Modification
76 Festo – MPAL-VI-EN – 2017-07a – English
7 Modification
7.1 General safety measures
Warning
Uncontrolled movements of the connected actuators and loose tubing can cause injury
to persons and/or damage to property.
 Before carrying out mounting, installation and maintenance work, switch off the
following power sources:
– Compressed air supply
– Operating voltage supply
– Load voltage supply
Note
 Handle all modules and components carefully.
 Screws must be placed so that the self-cutting threads can be used.
 Only tighten the screws by hand.
 Comply with tightening torques.
 Secure all of the components without distortion and mechanical tension.
 Replace damaged seals.
 Keep mounting surfaces clean and dry.
If the valve terminal was extended to the left of the last valve position, addresses can get
reassigned accidentally.