Festo MPAL-VI - Page 96

A Technical appendix
96 Festo – MPAL-VI-EN – 2017-07a – English
Mechanical
Cover plate
MPA1 [g] Approx. 24
MPA14 [g] Approx. 23
MPA2 [g] Approx. 44
Pressure regulator plate [g] Approx. 180
Materials
Valves, end plates GD-AL, PPS, PA6, PA6T, PBT, PPA-reinforced
Sub-bases,
supply modules
PPA, AW-AL
Exhaust plates PA66
Silencers PE
Electrical interlinking CuNi3Si1Mg, PBT, PA66
Seals Elastomer, NBR
Threaded rods, wire clamps Stainless steel, non-rusting
Screws Steel, ZnNi coating
Tightening torques (M
A
)
Left end plate, multi-pin connection plate
IP40 cover [Nm] 0.6 ± 10 %
Screw lock (UNC pin) [Nm] 0.5 ± 10 %
IP65/67 cover [Nm] 1.2 ± 10 %
Blanking plug, M20 [Nm] 1.2 ± 10 %
Cable connector
Straight [Nm] 3.0 ± 10 %
Lateral [Nm] 2.2 ± 10 %
Supply module
Flat plate silencer with
cover
[Nm]
1.3 ± 10 %
Exhaust air plate [Nm] 1.0 ± 10 %
Sub-base
Valve and blanking plate
MPA1 [Nm] 0.25 ± 20 %
MPA14 [Nm] 0.65 ± 20 %
MPA2 [Nm] 0.65 ± 20 %
Right end plate
Encoder plate
Round [Nm] 3.5 ± 10 %
Rectangular [Nm] 2.2 ± 10 %
Tie rod
Threaded rod, threaded sleeve,
screw
[Nm]
1.7 ± 10 %
Tab. A.1 Technical data: Mechanical