TROUBLESHOOTING 82
System problems
Clock is slow; time listed
on Configuration page
is earlier or later than
the actual time
One of the following:
• Missing or dead battery
on motherboard
• Faulty motherboard
1. Replace the battery on the motherboard, and then update the time in E100
Setup.
For information about E100 Setup, see Configuration and Setup
on the User Documentation CD.
2. Clear the CMOS (see page 57).
3. Replace the motherboard.
System performs slowly
or hangs periodically
One of the following:
• Missing or faulty
DIMM, DIMM installed
in wrong slot, or faulty
DIMM connections
• Faulty HDD
•Overheated
or faulty CPU
• Faulty motherboard
1. Check that the DIMM is installed in the correct slot (see page 38).
2. Reseat to remove any oxidation on the connector.
3. Reseat the cables to the HDD.
4. Replace the HDD cable.
5. Replace the HDD.
6. Make sure that the CPU on the motherboard is present and firmly seated,
and that the fan cable is connected.
7. Replace the CPU.
8. Clear the CMOS (see page 57).
9. Replace the motherboard.
Enclosed enclosed fan is
noisy, or is not producing
air
Fan is faulty
Replace the enclosed fan (see page 46).
TABLE 3 E100 errors
Symptom Possible cause Suggested action
To Next Page
Loading...