12
Description DMP10 / DMP20
Batch Modify > Views Settings
• Measurement view: selects the display
• Batch statistical display: selects the statistical characteristic variables to be
displayed
Batch Modify > Meas. unit
Sets the unit of measurement
Batch Modify > Offset
Sets the offset value
Batch Modify > More Settings > Measure Mode
Sets a measuring mode (single reading, free-running, )
Batch Modify > More Settings > Values rounding
Sets the number of decimal places for the values displayed
Batch Modify > More Settings > Save Readings
Saves measured readings (yes/no)
Batch Modify > More Settings > Air Reference
Sets the acquisition method for the air reference value
Batch Modify > More Settings > Calibration Assign
Assigns a different calibration
Menu Calibrations
Calibrations > New, starts a routine for creating a new calibration in the con-
nected probe.
Calibrations > List containing the calibrations stored in the connected probe;
After a calibration has been selected, the following functions are available:
• CALIBRATE
Starts the calibration routine for the selected calibration
• Rename
Renames the selected calibration
• Def. Cal. Check
Defines test settings for checking the selected calibration
• Check Calibration
Starts the checking procedure for the selected calibration
• Lock Calibration
Locks the selected calibration, possible only with a pre-defined lock code
To Next Page
Loading...
