Fisher Minute Mount 2 - Page 44

Lit. No. 43894, Rev. 02 44 November 1, 2016
OPERATING YOUR SNOWPLOW
Function Description of Operation
L
(Angle
Left)
Straight blades: Move the control lever
straight to the left to angle the blade left.
All others: With wings in a straight line,
move the control lever straight to the
left to move both wings to the angle left
position. The left wing retracts while the
right wing extends (XtremeV™, XV2™).
Function times out after 5.5 (straight
blades), 3.0 (XtremeV, XV2) or
3.25 (XLS™) seconds.
R
(Angle
Right)
Straight blades: Move the control lever
straight to the right to angle the blade right.
All others: With wings in a straight line,
move the control lever straight to the right
to move both wings to the angle right
position. The right wing retracts while
the left wing extends (XtremeV, XV2).
Function times out after 5.5 (straight
blades), 3.0 (XtremeV, XV2) or 3.25 (XLS)
seconds.
Scoop/Retract Blade Position
XtremeV, XV2, and XLS Blades
Moving the control lever from the center position
toward the word SCOOP or RETRACT on the face
of the control body will cause both wings to move
at the same time into the following blade positions.
Function Description of Operation
SCOOP
Move the control lever toward the word
SCOOP on the control face to extend both
wings forward into the scoop position.
Function times out after 5.0 (XtremeV,
XV2) or 5.5 (XLS) seconds.
RETRACT
Move the control lever toward the word
RETRACT on the control face to draw
both wings into the fully retracted/
vee position. Function times out after
3.0 (XtremeV, XV2) or 4.5 (XLS) seconds.
NOTE: If a control function times out before
the desired blade movement is complete,
release the lever to the center position, then
move it back into the desired function.