EasyManua.ls Logo

FiT FLYER - Page 165

FiT FLYER
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
EN
12
Category Code Displayedtext Remedy
04 09 Remote initialisation error
Checkwhetheranybuttonsarestuck.
Restart
thesystem.
05 08
Brake error during system
start
Check whether the brake lever is stuck or has
dirtonit.Restartthesystem.
06 0A Headlight error
Checkthelampanditscabling.Restartthe
system.
07 0B Rear light error
Checktherearlight/brakelight.
Restart
thesystem.
08 0C ECUinternalsensorerror
Restartthesystem.Iftheproblempersists,
contactyourFLYERspecialistretailer.
09 0D ECUcongurationerror
Restartthesystem.Iftheproblempersists,
contactyourFLYERspecialistretailer.
0A 0E ECUoverheated
YourFLYERe-bikeisoutsidethepermitted
temperaturerange.
Let
theFLYERcoolandrestartthesystem.
0B 0F ECUexcesscurrent
Restartthesystem.Iftheproblempersists,
contactyourFLYERspecialistretailer.
0C 10
Error in calculating average
values
There is not enough data to calculate
the
averagevalues.
0D 11 Maintenancerequest
TakeyourFLYERe-biketoyourFLYERspecial
-
ist
retailerassoonaspossibleforservicing.
0E 12
ECUservicing
YourFLYERe-bikeisconnectedtothemainte-
nance
software.
0E 2E
0E 2F
0E 30
0F 13 Side stand is unfolded The side stand is unfolded (motor assistance
not
possible).Ifthisisnotthecase,askyour
FLYERspecialistretailertoinspectthesensorin
thesidestand.
10 14 Folding mechanism is
open
The folding mechanism is open (motor assis-
tance
not
possible).Ifthisisnotthecase,askyour
FLYERspecialistretailertoinspectthesensorin
thesidestand.
33 18
Remote component connec-
tion error
Check
allconnectionstotheremote.
33 19
34 1A USBerror
USBcommunicationerror.Removethedevice
fromtheUSBportandrestartthesystem.
35 1B RTCbatteryisat
Check whether the time has been correctly
conguredandrestartthesystem.Iftheerror
persists,contactyourFLYERspecialistretailer.
36 1C Lightsensorerror
Clean the display and restart
the
system.Iftheproblempersists,contactyour
FLYERspecialist
retailer.
65 31 Battery
isat Rechargethebattery.
66 34
Battery overheated
Protection mode has been activated as the
batteryisoverloaded.Letthebatterycooland
restartthesystem.
66 35

Table of Contents