FiT FLYER - FLYER with Panasonic Drive and FIT; System Operation and Controls

5
EN
4
YourFLYERhasanautomaticprotection
against overheating. In the event of
overheating, this protection will switch
off the motor function until the motor has
reachedanon-criticaltemperature.The
remainingfunctions are continued, e.g.
youcanstilldrivewiththelightson.
When the bike is not in use, the system
will automatically turn off together with
thelightfunctionafter10minutes.This
durationcanalsobecongured,asex
-
plained
 in the chapter “Menu naviga-
tion”.
Therefore,alwaysbesuretoturn
onthedisplaybeforeeachride.
5. FLYER with
Panasonicdrive
and FIT
5.1 Operation with FLYER D1
displayandFLYERRC1andRC2
remotecontrols
YourFLYERwithPanasonicdriveisoperatedvia
theFLYER RC1orRC2remote control andthe
FLYERD1display.
FLYER RC1 and RC2 remote control operating
console
FLYERD1display
1.On/offbutton(pressforatleast
1 second to switch on)
2.
USBport
3.Display connector
RC1
RC2
Driveunit
Thedriveunitisane-bikemotorthatmayormay
nothave an integrated two-gear unit depending
onthemodel.Thedriveunitisoperatedviathe
FLYERremotecontrol(seeabove).
Withthetwo-gearunit,you can switch between
manual and automatic mode. Switch automatic
modeonandoffusingtheautomaticbutton(A).
In automatic mode, the motor changes gear in
-
dependently
 with the aid of sensor information.
Youcanswitchtomanualmodebypressingthe
automaticbuttonagainorusingthetoggleswitch.
Youcanusethetoggleswitchtochangegearat
anytime.
5.2 Operation
To activate the system, press the on/off button on
thedisplayforatleastonesecond.
The “Drive” menu will then be shown on the dis-
play.
The system can only be activated if a
sufcientlychargedbatteryisused.
To turn off the electrical system, press the on/off
buttonforatleastonesecond.
If the system does not detect any rider activity
for ten minutes, it turns off automatically to save
energy (this idle time can be congured as ex
-
plained
under"Menunavigation").
The FLYER D1 display is operated using the
joystick on the FLYERremote control operating
console, so that your hands can remain on the
handlebarswhileyouride.
Automatic
button
1
2
3