FiT FLYER - Maintenance and Replacement of Wearing Parts

45
EN
44
• Ifnecessary,cleanthebrakediscswitha
suitable brake cleaner approved by the
manufacturer
•
Clean all bearings as required and lubricate
them with suitable lubricant approved by the
manufacturer
• Clean suspension elements as required and
lubricate them with original lubricant approved
by the suspension element manufacturer
• Clean all moving parts for which lubrication is
intended (especially quick-release fasteners,
quick-release axles and joints) as required
and lubricate them with a suitable lubricant ap
-
proved by the manufacturer
Allow
 your FLYER specialist retailer to instruct
you.
Whattodoafterridinginrain,snoworwetcon
-
ditions:
(in
additiontothepointsunder“Aftereachride”)
FLYER rider
• Clean the chain and lubricate it with a suitable
lubricant approved by the manufacturer
• Clean the brake
• Clean the gear system
• Checkthatallcomponents are sufcientlylu
-
bricated
Allow
 your FLYER specialist retailer to instruct
you.
Monthly–FLYERrider
Checkthermattachmentofallscrews,nutsand
quick-releasefasteners
Everyyearorafterevery1000km,whichever
occursrst
FLYERspecialistretailer
• Lubricationofallmovingpartsfor
which lubrication is intended
(excluding brake surfaces)
•
Visual inspection of the frame and of
components for cracks and damage
•
Mendpaintdamage
• Replace parts with rust spots
• Treat all bare metal parts (excluding brake
surfaces) against corrosion (rust)
• Change defective or damaged parts
• Check the wheels and centre them as
required
• Check the tension of the spokes
• Check and clean the
chain/sprocket/cogset
•
Lubricatethechainwithasuitablelubricant
• Check the rim for wear
• Check the brake pads for wear
• Checkthatallscrews,nuts,quick-release
axlesandquick-releasefastenersarermly
attached
• Check the brake system and quick-release
axlesandadjustthemorreplacepartsifnec
-
essary
•
Checkthegearsystemandadjustorreplace
parts of it if necessary
• Check the hubs
• Check the headset
• Check the pedals
Onlyusecleaningagentsandlubricants
that are recommended or approved by
thecomponentmanufacturer.
Please note that not all lubricants and
care products are suitable for your
FLYER. By using unsuitable lubricants
or care products, you can damage or im
-
pact
 the functionality of your FLYER
e-bike.
Ensure that the brake pads, brake discs
and brake surfaces on the rims are not
exposedtocleaningorservicinguidsor
oils, as this reduces the performance of
thebrakes.
22.1 Maintenanceand
replacementofwearingparts
Components to be changed may only be
replaced with identical, original parts.
Wearing parts too may only be replaced
withidentical,originalcomponents.
Using any parts other than the original
oneswillcausethemanufacturer’sliabil-
ity for material defects and/or the manu-
facturer’s
 warranty service to become
void.Thereisalsoanincreasedriskof
accidentsorfalls.