EasyManua.ls Logo

FiT FLYER - Operating Quick-Release Fasteners and Axles; Setting Up Seating Position

FiT FLYER
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2928
tions: Ensure that the axle, dropouts and
quick-release mechanisms are free of
dirt.Takecarethattheyarecorrectlyat-
tached
atalltimes.
Contact your FLYER specialist retailer
and have your vehicle checked if you
arenotsure.
Check that all quick-release fasteners
and quick-release axles are rmly at-
tached,
even if your FLYER only re-
mained
unsupervisedforashorttime.
You may only start riding when all
quick-release fasteners are rmly
closed.
11.2 Settinguptheseatingposition
Theseat,handlebarsandstemmustbeadjusted
to your body mass and the desired sitting position
inorderto useyourFLYER safely andcomfort-
ably.
OnlyallowyourFLYERspecialistretailer
to work on the handlebars and stem.
These are components which are crucial
for your safety, so incorrect work and
tools in this area of the bicycle could
leadtoseriousfalls.
The seat and stem can be attached with
screwconnectionsorquick-releasefas-
teners.
Always tighten the screw con-
nections
with the correct torque. This
can be found in the enclosed technical
dataonyourFLYER.
Seat height
90°arm-upperbodyangle
Inordertotransferthepedalforceeffectivelyto
the pedals, you must set your seat to the appro-
priate
height.
FindtheidealpositionbysittingontheFLYERat
the vertical crank position and placing the heel of
yourbarefootontothepedalinitslowestposition.
Now the bottom leg should be stretched. If this
isnotthecase,dismount,adjusttheseatinthe
requireddirectionandtryagain.
Ensure that the quick-release fastener is com
-
pletely
closedaftertheadjustmentprocess.
There are markings on the seat post
which show how far it can be pulled out
oftheframe.Neverpulltheseatpostbe-
yond
themaximumlengthmarking.Oth-
erwise the seat post may buckle or
break.
Ifyourequirealongerseatpost
to reach the correct sitting position, talk
toyourFLYERspecialistretailer.
Neverridewithaseatpostextendedfur
-
ther than the maximum marker as this
could
resultinseriousfallsandinjury.
Childrenandpersonswhoarenotcon-
dent cyclists should be able to touch the
ground
withthetipsofbothfeet.Other-
wise, when stopping they run the risk of
falling
andsufferingseriousinjury.
Seat position
Thehorizontalpositionoftheseatcanandshould
besettoo.
Youareintheoptimalridingpositionwhenyour
front knee is directly above the pedal while the
crankishorizontallyaligned.
The horizontal adjustment of the seat may only
be performed within the markers and within the
rangespeciedbythemanufacturer.
Test whether the seat post and the seat
arermlyattachedbeforeyourideoff.
To do this, hold the seat at the front and
backandattempttoturnit.Itshouldnot
move.
ST OP

Table of Contents