14 Data logger
FLUXUS G809 14.3 Configuration of the data logger
125
UMFLUXUS_G809V2-2EN, 2020-06-25
Totalizer storing
It is possible to store the currently displayed totalizer only or to store one value for each flow direction.
• Select one to store the currently displayed totalizer value only. This can apply for the positive and negative totalizer.
• Select both to store the totalizer values for both flow directions.
• Press ENTER.
Signal amplitude storing
• Select on to store the amplitude of the measured signal together with the measured values.
• Press ENTER.
Fluid sound speed storing
• Select on to store the fluid sound speed together with the measured values.
• Press ENTER.
Diagnostic values storing
• Select on to store the diagnostic values together with the measured values.
• Press ENTER.
Option of flow velocity storing
• Enter the HotCode 007043.
• Select auto to store the flow velocity as an integer. Select full to store the flow velocity as a floating-point number.
• Press ENTER.
Notice!
The storage mode does not affect the outputs.
Notice!
Storage mode = average
The average of the physical quantity and other measurands assigned to the measuring channel, will be calculated.
If the storage rate < 5 s is selected, sample will be used.
If no average could be calculated over the complete storage interval, the value will be marked as invalid. The ASCII
file will contain ??? for invalid average values of the data and ?UNDEF instead of invalid temperatures.
Special Funct.\SYSTEM settings\Storing\Quantity Storage
Special Funct.\SYSTEM settings\Storing\Store Amplitude
Special Funct.\SYSTEM settings\Storing\Store c-Medium
Special Funct.\SYSTEM settings\Storing\Store diagnostic
Storage resolut.
auto >FULL<
To Next Page
Loading...
