8 Start-up
8.1 Start-up settings FLUXUS G809
2020-06-25, UMFLUXUS_G809V2-2EN
82
8.1 Start-up settings
When starting up the transmitter for the first time, the following settings are required:
• language
• units of measurement
• date/time
These displays will only be indicated once when the transmitter is switched on for the first time.
The available transmitter languages are displayed.
• Select a language.
• Press ENTER.
The menus are displayed in the selected language.
• Select metric or imperial.
• Press ENTER.
• Select yes if the transmitter is to be used in the region of Canada.
• Press ENTER.
This display will only be indicated if imperial is selected.
The current time is displayed.
• Press ENTER to confirm the time or to set the current time via the keys and .
• Press ENTER.
The current date is displayed.
• Press ENTER to confirm the date or to set the current date via the keys and .
• Press ENTER.
Notice!
The transmitter and transducers have to be checked to ensure proper condition and operational safety before each
use. The transmitter housing must always be closed during operation. Observe that maintenance work must be con-
cluded.
Select language
Engineer. Units
CANADA-REGION
TIME
DATE
To Next Page
Loading...
