6 Installation
6.2 Transducers FLUXUS G809
2020-06-25, UMFLUXUS_G809V2-2EN
38
6.2.3.2 Transducer arrangement
The transducer mounting with mounting rails can have various arrangements:
6.2.3.3 Mounting the transducer types ****LI**
If the nameplate of the transducers ****LI** is removed from the transducer cable during installation, it has afterwards to be
remounted and fixed to the transducer cable using the provided cable tie. The heat shrink tubing must not be reused.
Fig. 6.11: Transducer arrangement in mounting rails
Fig. 6.12: Nameplate on the transducer cable
1 – transducers
2 – nameplate
3 – heat shrink tubing
4 – cable tie
reflection arrangement,
1 rail
reflection arrangement,
2 rails
diagonal arrangement,
2 parallel rails
diagonal arrangement,
2 displaced rails
before mounting: after mounting:
1 1
2 2
3
4
To Next Page
Loading...
