FlexRadio Systems Tuner Genius XL


Page18of 72
Copyright 2021 FlexRadio. All Rights Reserved. 7 June 2021(FW:0.9.12, Utility: 0.9.12)
Duringpower‐up,thedisplaywillbrieflyshowasplashscreenlikethefollowing:

Figure 6-4 Front Panel Splash Screen
Afterthestart‐upsequence,thetunerwillqueryyourlocalareanetworkDHCPserviceforanavailableIP
addressandautomaticallyconfigurethenetworksettings.IfaDHCPserviceisnotavailableordoesnot
respond,thetunerwillself‐assignaLink‐LocalIPAddressfollowingtheRFC‐3927
specification.
i–IfthedisplayedIPAddressbeginswith169.254,thetunerself‐assignedaLink‐LocalIPAddress.
DependingonyourLocalAreaNetwork(LAN)configuration,thismayindicateanetworkproblemand
preventfurthersetup.ContactFlexRadioSupportforassistance.
Whenthestart‐upsequencecompletesandresolvesan
IPaddress,thetunerwillenterOperatemodeand
announceitspresenceonyourLocalAreaNetwork.ThefirmwareversionandIPaddressaredisplayedatthe
bottomofthescreen.

Initial Operating Mode
 