FlexRadio Systems Tuner Genius XL User Manual


Page64of72
Copyright 2021 FlexRadio. All Rights Reserved. 7 June 2021(FW:0.9.12, Utility: 0.9.12)
10 Factory Reset the Tuner Genius XL
TheconfigurationoftheTunerGeniusXLcanberesettothe"factorydefaults"usingthefollowingprocedure:
 Turnthetuneroffusingthepowerswitchonthebackpanel.
 PressandholdtheBYP ASS/OPERA TEfrontpanelbutton.
 TurnthetunerON
 ContinueholdingtheBYPASS/OPERATEbutton
untilthe"ConfigReset"messageappearsonthefront
panel.
 ReleasetheBYP ASS/OPERA TEbutton.
 StarttheTunerGeniusXLWindowsUtilityandconnecttothetuner.
 SetallconfigurationoptionsasdesiredandthenclickSAVE.IfyoudonotclickSAVE,thenewsettings
willnot
beretained,andyouwillhavetoreruntheresetprocedure.
11 Alarms, Warnings and Messages
Ifthetunerdetectsanoperationalerror,amessageisdisplayedonthemaindisplayandontheWindows
Utility,asshownbelow:
11.1 Alarms
Whenanalarmisraised,thetunerbypassestoprotectitselffromdamage.ThealarmisclearedwhenthePTT
isreleased.
Alarm Description
FREQUENCYOUTOFRANGE Banddatanotdetected.Checkyourbanddatasettings/connections/sources.
WRONGBAND Loremipsum
HIGHPOWER Drivepoweristoohightocreateatuningsolution
>10:1SWR AntennaSWRisabovethemaximumthatcanbeautomaticallytuned.
However,youmayachieveamatchforSWR>10:1byusingthemanual
tuningcontrols.
11.2 Warnings
Thefollowingarewarnings.
Warning Description
LOWDRIVE Loremipsum
PTTUNKEY Loremipsum
11.3 Messages
Thefollowingaremessages.

FlexRadio Systems Tuner Genius XL Specifications

General

Brand	FlexRadio Systems
Model	Tuner Genius XL
Category	Tuner
Language	English