FlexRadio Systems Tuner Genius XL


Page22of72
Copyright 2021 FlexRadio. All Rights Reserved. 7 June 2021(FW:0.9.12, Utility: 0.9.12)
6.2.3 Network Tab: Configuring the Network
TheTunerGeniusXL is configuredatthefactory(orafterafactoryreset)touseDHCPIPaddressingandwill
automaticallysecureanIPAddressappropriateforyournetworkwhenitstarts.Thisconfigurationshouldbe
sufficientformostsituations.

YoucanusetheNetworktabtoassigna
staticIPAddress,astaticNetworkMask,andaGatewayaddress.Static
IPaddressesaredesirableinsomenetworkconfigurationsbutrequirespecifictechnicalknowledgeofthe
network.Mostconfigurationswillnotrequirethesesteps.Ifyoudon'tneedanyoftheseoptions,please
proceedtothenextsection.
Thenetwork
settingsscreenperformsbasicvalidationofthenetworksettings.NotetheredXnexttoan
incorrectlyformattedsubnetmaskbelow.

IfyouarenotfamiliarwiththerulesofsettingorusingstaticIPaddressesbutbelieveyouneedtoconfigure
one,pleasesubmitaHelpDeskticketforassistance.

Whenyouhavecompletedthenetworkconfiguration,clickSavetoinstructtheTunerGeniusXLtosavethe
configurationbeforeperformingthenextstep.
i–ThetunerwillresetwhenSaveispressed.
i–ItisunnecessarytoexitandrestarttheTunerGeniusXLWindowsUtilityafter
Saveispressed.