FlexRadio Systems Tuner Genius XL


Page58of72
Copyright 2021 FlexRadio. All Rights Reserved. 7 June 2021(FW:0.9.12, Utility: 0.9.12)

Figure 8-2 Shows a single FLEX-6600M configured
for SO2R Operations.
UsetheFlexRadiotabtoconfigurethetunertopairwithFLEX‐6000Seriestransceivers.
Beforebeginningthisconfiguration,makesureyourFLEX‐6000Seriestransceiversareturnedonandconnected
tothesameLocalAreaNetworkthathoststheTunerGeniusXL.TheTunerGeniusXLWindowsUtilitywill
discover
theFLEX‐6000Seriestransceiversoverthenetwork.
Youmustselecttheserialnumberoftheradioconnectedtoeachport.Leavetheserialnumberfieldblankif
youdonotwantthatportpairedwithaFLEX‐6000Seriestransceiver.
SelecttheantennaportfromtheFLEXradio(ANT1
orANT2)connectedtothetunerport(AorB).
BesuretoselectLANforthePTTsource;usingRCAasthePTTsourceforFLEX‐6000Seriestransceiversisnot
recommended.
ClicktheSavebuttontostoretheconfigurationafterthechoiceshavebeenmade.