12. Maintenance
12.1 Cleaning and Storage
Wipe the housing with a damp cloth as needed. Use a high quality lens wipe to remove
dirt or smudges from the meter lenses and display window. Please do not use abrasives
or solvents to clean the meter housing, lenses, or display window.
If the meter is not to be used for an extended period, remove the batteries and store
them separately.
12.2 Battery Replacement
The Battery symbol flashes with no ‘bars’ when the batteries have reached a critical level.
The meter displays readings within specifications while the low battery indicator is on.
The meter powers off before it displays an out of tolerance reading.
WARNING: To avoid electrical shock, disconnect the meter from any connected circuits,
remove the test leads from the meter terminals, and set the function switch to the OFF
position before attempting to replace the batteries.
1. Unscrew and remove the battery compartment cover.
2. Replace the three (3) standard AA batteries, observing correct polarity.
3. If using the Model TA04 rechargeable lithium polymer battery system, please
recharge the rechargeable battery.
4. Secure the battery compartment cover.
12.3 Disposal of Electronic Waste
As with most electronic products, this equipment must be disposed of in an
environmentally friendly way, and in accordance with existing regulations for electronic
waste. Please contact your FLIR Systems representative for more details.
To Next Page
Loading...
Need help?
General
