3. Introduction
Thank you for selecting the FLIR CM275 Imaging Clamp meter with IGM
TM
(Infrared
Guided Measurement) and Bluetooth®. The CM275 is a True RMS 600A AC/DC clamp
meter with a radiometric Lepton Thermal Imaging system, integrated VFD Mode, Inrush
Current capture, a Lo Z mode for eliminating ‘ghost’ voltages, Bluetooth®
communications capabilities, and many others as listed in the Key Features section
below. This device is shipped fully tested and calibrated and, with proper use, will
provide years of reliable service.
3.1 Key Features
6000 count digital TFT display with bargraph
Built-in Infrared Imager with gallery mode for storing, viewing, and transmitting images via
Bluetooth®
Capture fully radiometric thermal images where a temperature measurement is saved for
each display pixel
Imager features Laser pointer, cross hairs targeting, and an intuitive menu system
High power work lights built-in
Auto Range True RMS AC/DC 600 A capability
Auto Range True RMS AC/DC 1000 V capability
Frequency AC bandwidth (45-400Hz)
Frequency Measurements to 60KHz
Flex clamp adaptor input for FLIR TA72_TA74 and other clamp adaptors
Input over-voltage warning
Automatic Datalogger memory (40,000 readings over 10 sets) with selectable sample rate and
Bluetooth® transmission capability
Resistance and Continuity measurements
Capacitance and Diode measurements
Data HOLD
Inrush current
DCA zero function
Low Z (Impedance) mode
Minimum/Maximum memory
Integrated VFD mode (Low-pass filter)
Auto power off (can be disabled or preset to 1, 2, 5, or 10 minutes)
Jaw opening 35mm (1.38”)
Easy-access battery cover mechanism
Optional FLIR TA04 battery charging system
Micro USB port (battery compartment) for transferring images/data logs to PC; operates
similarly to a conventional thumb drive
Safety Category Rating: CAT IV-600V, CAT III-1000V
Equipped with batteries, test leads, carry pouch, and Quick Start booklet.
To Next Page
Loading...
Need help?
General
