FLIR RAYMARINE E125 - Automatic Route Generation

It can now be displayed, edited and erased etc.
in the same way as other routes in the system.
3. Select OK to conrm.
4. Select Edit to change the name and line color of
the created route.
Building a route from a track displayed on the
chart
From the chart application:
1. Select the required track.
The track context menu is displayed.
2. Select Create Route From Track.
On completion, the maximum deviation of the
route from the recorded track is displayed in a
pop up message and the new route is added to
the route list. It can now be displayed, edited
and erased etc. in the same way as other routes
in the system.
3. Select OK to conrm.
4. Select Edit to change the name and line color of
the created route.
Automatic route generation
Automatic route generation can be used to
automatically create the shortest route between 2
waypoints. Automatic route generation can be used
when creating new routes or when adding a route
leg to an existing route.
The generated route is based on the data available
on compatible cartography compared with user
dened settings. Waypoints automatically generated
will be restricted from entering areas that do not
adhere to the user dened settings.
Important: The following restrictions apply:
• Automatic route generation can only be used
when generating routes within the area covered
by your compatible cartography.
• Automatic route generation can be used
between waypoints less than 100 nm apart.
• Automatic route generation always uses
the cartography’s minimum depth reading
when calculating routes. Please refer to the
Differences between automatic route generation
functions
section for further details.
• Automatic route generation will fail if the
generated route will exceed the maximum
waypoint or route capacity of the MFD.
• Automatic route generation will also fail if
insufcient cartographic data is available.
Caution: Easy Routing -
Dredged areas
The C-MAP
®
Easy Routing feature will
ignore some hazards in dredged areas.
Easy Routing is intended for passage
planning between harbors rather than
within a harbor.
Warning: Trafc separation
Automatic route generation features
do not adhere to the Trafc Separation
Schemes identied in Rule 10 of the
International Regulations for Preventing
Collisions at Sea 1972 as amended.
Raymarine
®
therefore recommends
that you do NOT use Automatic route
generation to create any part of a route
which will cross trafc lanes or pass
near to trafc separation lines. In these
situations Automatic route generation
MUST be switched Off and the route
or route leg MUST be built manually,
ensuring compliance to the rules laid out
in the above regulations.
Automatic route generation - compatible
cartography
Automatic route generation requires compatible
Navionics
®
or C-MAP
®
cartography.
The Navionics
®
Autorouting feature is available on
the following cartography:
• Navionics Updates
• Navionics Platinum
• Navionics Platinum+
The Navionics
®
Dock-to-dock feature is available
on the following cartography:
• Navionics+
• Navionics Platinum+
• Navionics Updates
• Navionics Hotmaps
Waypoints, Routes and Tracks
153