FLIR RAYMARINE E125 - NMEA Set-Up Menu

NMEA Set-up menu
This menu enables you to congure settings for NMEA devices.
Menu item Description Options
Bridge NMEA Heading
If set to ON, NMEA heading data will be bridged
onto the SeaTalk data bus, and will be sent to
all NMEA-connected devices. If set to OFF,
NMEA heading data will NOT be bridged onto
the SeaTalk bus. An example of a use for this
setting is when using MARPA with an external fast
heading sensor, in which case you should set this
option to OFF to ensure that all NMEA-connected
units receive heading data from the external
heading sensor.
• On
• Off (default)
NMEA Output Settings
Allows you to enable or disable the individual
NMEA “sentences” that are sent by the
multifunction display to any devices connected
the NMEA output port.
• List of available sentences.
NMEA Input Port 1
Enables you to specify the appropriate port speed
for the equipment connected to NMEA Input port
1. Use the AIS 38400 option for AIS receivers.
• NMEA 4800
• AIS 38400
NMEA Input Port 2
Enables you to specify the appropriate port speed
for the equipment connected to NMEA Input port
2. Use the AIS 38400 option for AIS receivers.
• NMEA 4800
• AIS 38400
82