FLIR RAYMARINE E125 - Expanding and Retracting a Splitscreen Application; Expanding and Retracting a Splitscreen Application Using Menu Options; Initial Set up Procedures; Minimum Safe Vessel Depth

to switch the active application between full and
splitscreen.
3. Press the Back button or the Switch Active
button to exit switch mode.
Expanding and retracting a splitscreen
application
The following steps apply to MFDs that have a
Switch Active Pane button or have an MFD keypad
connected.
With a page featuring multiple applications displayed:
1. Select the application you want to expand.
2. Press and hold the
Switch Active Pane
button.
The active pane is expanded to fullscreen.
3. To revert back to the splitscreen view press and
hold the
Switch Active Pane button again.
Expanding and retracting a splitscreen
application using menu options
The following steps apply to MFDs that do not have
a Switch Active Pane button.
With a page featuring multiple applications displayed:
1. Select Menu.
2. Select Fullscreen View to expand the active
application in fullscreen, or
3. Select Splitscreen View to revert to the
splitscreen page view.
3.12 Initial set up procedures
Once your display has been installed and
commissioned, Raymarine recommends that you
complete the Startup wizard and perform some
additional procedures.
Startup wizard
When you power-up the display for the rst time or
after a system reset a Startup Wizard is displayed.
The wizard guides you through the following basic
conguration settings:
1. Language
2. Boat type
3. Congure Units (Units of measure)
4. Boat Details (Parameters)
Note: These settings can also be set at any time
using the menus accessible from Homescreen
> Customize.
Additional settings
In addition to the settings covered by the Wizard,
it is also recommended that the following initial set
up tasks are completed:
• Designate the data master
• Set your date and time preferences
• Select data sources
• Familiarize yourself with the product using
Simulator Mode
Warning: Minimum Safe
Depth, Beam and Height
Depending on cartography vendor, the
minimum safe settings are used during
automatic route generation, they are used
to restrict created routes from entering
water that is not suitable for the vessel.
Data is taken from compatible cartography.
Minimum safe settings are user dened
calculations. As both of these factors
are outside of Raymarine’s control;
Raymarine will not be held liable for
any damage, physical or otherwise,
resulting from the use of the automatic
route generation feature or the Minimum
Safe Depth, Minimum Safe Beam or
Minimum Safe Height settings.
Minimum safe vessel depth
As part of the Initial startup wizard the Minimum
Safe Depth value can be set.
Minimum Safe Depth can be established by adding
together:
• Maximum Vessel Draft (i.e. the distance from the
waterline to the lowest point of a vessel’s keel.)
• Safety Margin (an adequate clearance below the
keel to allow for draft variation and changes in
water or bottom conditions.)
46