18.4 Displaying multiple camera
feeds using Quad View
When an IP camera is available on the network, the
Camera application can be set to Quad View. In
Quad View up to 4 camera feeds can be viewed
simultaneously.
Quad View can consist of up to 4 x IP feeds or 1 x
analog feed and up to 3 x IP feeds.
To enable Quad View, from the Camera application:
1. Select Menu.
2. Select Camera View.
3. Select Layout: so that Quad View is displayed.
4. Arrange the feeds by selecting a feed in each
of the Top-Left, Top-Right, Bottom-L and
Bottom-R menu options as required.
Analog feeds can only be displayed in the top
left corner.
5. The top left corner can also be set to cycle
through all available analog and IP feeds using
the cycling options available in the Top-Left
menu.
See
18.5 Camera cycling for details of cycling
feeds.
Recording, taking photos, naming feeds and
adjusting the video image are not supported in Quad
View; however it is possible to switch to Quad View
whilst recording in Single View.
Note: Except for gS Series displays, Quad View
is not available on MFDs with a 9 inch or below
screen size when the Camera application is being
viewed as part of a splitscreen page.
Note: Displaying multiple IP feeds on multiple
MFDs simultaneously may cause some feeds to
not be displayed.
Using onscreen controls
On touchscreen displays, onscreen controls are
available to quickly switch between Quad View and
Single View.
In Quad View:
1. Select the feed.
The Expand icon
is displayed.
2. Select the Expand icon to view the feed in
fullscreen.
3. Select the fullscreen feed.
The Quad View icon
is displayed.
4. Select the Quad View icon to switch the Camera
application back to Quad View.
292
To Next Page
Loading...