FLIR RAYMARINE E125 - Important Software Requirements for Multiple Sonar Systems; Selecting the Sonar Channel; Displaying Multiple Sonar Channels; Depth Data Source

Note:
1. The channels available are dependent on the
sonar module and its connected transducer.
2. DownVision
TM
sonar modules include both a
DownVision
TM
channel and a traditional sonar
channel.
3. SideVision
TM
sonar modules include 1
SideVision
TM
channel, the view icons can be
used to switch between left and right views.
Important software requirements for
multiple sonar systems
If your system includes more than one source of
sonar data you must ensure that any CP300 or
CP450C sonar modules are running software version
v4.04 or later.
This applies to systems which include:
• Any number of MFD(s) with an internal sonar
module plus a CP300 and / or CP450C sonar
module; or
• No MFD(s) with an internal sonar module, but
more than one CP300 or CP450C sonar module.
This does NOT apply to any systems that do NOT
include a CP300 or CP450C sonar module.
Note: For software downloads and instructions
on how to update the software for your product(s),
visit
www.raymarine.com/software.
Selecting the sonar channel
To select the channel you want to display follow the
steps below.
From the Sonar application:
1. Select Menu.
2. Select Channel.
The Channel selection page is displayed.
3. Select the tab for the sonar module you want to
use.
A list of available channels for the selected sonar
module is displayed.
4. Select a channel from the list.
The Channel selection page will close and the Sonar
application will now show the selected channel.
Displaying multiple sonar channels
Up to 4 sonar channels can be viewed at the same
time by creating a custom splitscreen page that
includes multiple Sonar application instances.
Important: Your ping rate may be reduced if you
display different channels from the same sonar
module at the same time.
1. Create a new splitscreen page using multiple
instances of the Sonar application.
Refer to the
Changing an existing page on the
homescreen
section to nd out how to create a
page.
2. Open the newly created page.
3. Select the OK button in one of the sonar panes.
4. Select to channel that you want to view in the
selected pane.
Refer to the
Selecting the sonar channel section
for details on selecting a sonar channel.
5. Repeat steps 3 and 4 for each pane on the
splitscreen page.
Depth data source
Where multiple sources of depth data exist on a
system and the depth Data Source is set to Auto the
system will automatically select the optimum source
for depth data.
The system will set the data source for depth
according to the priority table below:
1
st
CP470 / CP570 SeaTalk
hs
2
nd
CP370 SeaTalk
hs
3
rd
CP450C / CP300 SeaTalk
hs
4
th
DSM300 / DSM30 SeaTalk
hs
Sonar (Fishnder) application
217