17.3 List of data items
Categories of data available to display in the data
application, databoxes, databar, and expanded
databar are shown below. Dial graphics are not
available in databoxes or databars.
The following table shows the data items available
by category.
Note:
* Only available in the Data application.
** Not available in the Data application.
*** The Battery, Engine, Fuel and Tanks menus will
display 1 set of data items per congured device
(e.g. if the system has been congured with 3
engines then 3 sets of engine data items will be
displayed).
Data Category Description Data Items
Battery ***
Battery status • Battery Amps
• Battery
Temperature
• Battery Voltage
• Battery Charge
Boat
Types of data
generated by
your vessel. For
example, tank
levels.
• Rate of Turn
• Heel Angle
• Trim Tabs *
Depth Depth data. • Depth
• Maximum
Depth
• Minimum Depth
Distance
Types of data
related to distance
travelled by your
vessel. For
example, trip
distance.
• Log & Trip
• Log
• Trip
• Ground Log and
Trip
• Ground Log
• Ground Trip 1
• Ground Trip 2
• Ground Trip 3
• Ground Trip 4
Data Category Description Data Items
Engine *** Types of data
generated by
engines. For
example, oil
pressure.
• RPM
• RPM & SOG
• Coolant
Temperature
• Coolant
Pressure
• Oil Temperature
• Oil Pressure
• Oil Pressure
& Coolant
Temperature
• Transmission
Oil Temperature
• Transmission
Oil Pressure
• Transmission
Gear
• Boost Pressure
• Fuel Pressure
• Fuel Flow Rate
• Fuel Flow (Inst)
• Fuel Flow (Avg)
• Engine Hours
• Engine Trim
• Alternator
• Engine Load
Fuel *** Types of data
related to the
fuel system. For
example, fuel
levels.
• Fuel Level (%)
• Total Fuel (%)
• Total Fuel (vol)
• Fuel Flow Total
• Economy
• Estimated Fuel
Remaining
• Distance to
Empty
• Time to Empty
• Fuel Used (Trip)
• Fuel Used
(Season)
Data application
279
To Next Page
Loading...