3.18 Memory cards and chart
cards
MicroSD memory cards can be used to back up /
archive data (e.g. Waypoint, and Tracks). Once
data is backed up to a memory card old data can
be deleted from the system, creating capacity for
new data. The archived data can be retrieved at any
time. Chart cards provide additional or upgraded
cartography.
It is recommended that your data is backed up to a
memory card on a regular basis. Do NOT save data
to a memory card containing cartography.
Compatible cards
The following types of MicroSD cards are compatible
with your display:
• Micro Secure Digital Standard-Capacity
(MicroSDSC)
• Micro Secure Digital High-Capacity (MicroSDHC)
Note:
• The maximum supported memory card capacity
is 32 GB.
• MicroSD cards must be formatted to use either
the FAT or FAT 32 le system format to enable
use with your MFD.
Speed class rating
For best performance it is recommended that you
use Class 10 or UHS (Ultra High Speed) class
memory cards.
Chart cards
Your product is pre-loaded with electronic charts
(worldwide base map). If you wish to use different
chart data, you can insert compatible chart cards into
the unit's memory card reader.
Use branded chart cards and memory cards
When archiving data or creating an electronic chart
card, Raymarine recommends the use of quality
branded memory cards. Some brands of memory
card may not work in your unit. Please contact
customer support for a list of recommended cards.
Removing MicroSD card from its
adaptor
MicroSD memory and cartography chart cards are
usually supplied inserted into an SD card adaptor.
The card will need to be removed from the adaptor
before inserting into your display.
3.19 Simulator mode
The Simulator mode enables you to practice
operating your display without data from a GNSS
receiver, Radar scanner, AIS unit, or Sonar module.
The simulator mode is switched on / off in the
System Setup Menu.
Note: Raymarine recommends that you do NOT
use the simulator mode whilst navigating.
Note: The simulator will NOT display any real
data, including any safety messages (such as
those received from AIS units).
Note: Any system settings made whilst in
Simulator mode are NOT transmitted to other
equipment.
Enabling and disabling simulator
mode
You can enable and disable simulator mode by
following the steps below.
With the homescreen displayed:
1. Select Set-Up .
2. Select System Settings.
3. Select Simulator:.
4. Select On to turn simulator mode on, or
5. Select Off to turn simulator mode off.
Note: The Demo movie option is for retail
demonstration purposes only.
56
To Next Page
Loading...