FLIR T10 Series

About FLIR Tools/FLIR Tools+
7
7.2 Workflow
7.2.1 General
When you carry out an infrared inspection you follow a typical workflow. This section
gives an example of an infrared inspection workflow.
7.2.2 Figure
7.2.3 Explanation
1. Use your camera to take your infrared images and/or digital photos.
2. Connect your camera to a PC using a USB connector.
3. Import the images from the camera into FLIR Tools/Tools+.
4. Do one of the following:
• Create a PDF imagesheet in FLIR Tools.
• Create a PDF report in FLIR Tools.
• Create a non-radiometric Microsoft Word report in FLIR Tools+.
• Create a radiometric Microsoft Word report in FLIR Tools+.
5. Send the report to your client as an attachment to an e-mail.
#T559954; r. AP/42311/42335; en-US
15