Handling the camera13
13.12.2 Procedure
Follow this procedure:
1. Push the joystick to display the menu system.
2. Use the joystick to go to
(Settings).
3. Push the joystick to display the Settings menu.
4. Select Device settings and push the joystick.
5. Select Lamp & laser and push the joystick.
6. Select Enable lamp & laser + Use lamp as flash and push the joystick.
Note You can also assign the function Switch camera flash On <> Off to one of the pro-
grammable buttons. Select
(Settings) > Programmable buttons.
13.13 Changing lenses
Note Do not touch the lens surface when you change lenses. If this happens, clean the
lens according to the instructions in 31.2 Infrared lens, page 200.
Follow this procedure:
1. Take a firm grip around the outermost part of the lens.
#T559954; r. AP/42311/42335; en-US
35
To Next Page
Loading...
Need help?
General
