Why is the entire screen “bluish” on my Flomec Measuring Instruments?
If the entire screen of your Flomec Measuring Instruments appears “bluish”, it means the ambient or fluid temperature is reaching upper heat limits. If the display is still readable, it's fine. If the bluish tint is a nuisance, consider Remote Display kit options.
Why are the totals / flowrate inaccurate on my Flomec Measuring Instruments?
Inaccurate totals or flowrate in Flomec Measuring Instruments can occur due to several reasons. First, the field calibration might not have been performed properly; in this case, you should field calibrate again or select Factory Calibration. Second, the factory calibration might not be suitable for the liquid being measured, so perform a field calibration. Also, the meter may be operating below the minimum flowrate, so increase the flowrate. The meter or turbine bearings may be partially clogged with dried liquid, requiring you to remove and carefully clean the meter, ensuring the rotor spins freely. Sealant material wrapped around the meter rotor can also cause this, so remove the rotor if applicable and ensure it spins freely. Finally, incorrect installation, such as being too close to ...
Details the intended application, power source, and battery requirements for the computer electronics.
Outlines operator responsibilities and critical warnings for safe operation and handling.
Details warnings for ignition risk, static discharge, battery hazards, and flammable liquids.
Covers physical dimensions, operating temperatures, electrical parameters, and temperature limits.
Details power supply, battery life, standard features, and optional daughter board modules.
Provides step-by-step instructions for installing the computer electronics onto a turbine housing.
Explains the computer display, activation, normal operation, and button functions.
Provides general notes for user configuration menus and how to enter the mode.
Describes calibration methods, pipe diameter input, and daughter board module configurations.
Addresses problems like inaccurate readings, button malfunctions, display errors, and flow anomalies.
Provides guidance on battery care, approved types, and the replacement process.
Lists replacement parts, contact info for service, and details the limited warranty.
General| Brand | Flomec |
|---|---|
| Model | Q9 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
