Fluke 5080A Service Manual

1
Introduction
XW Warning
If the 5080A Calibrator is used in a manner not specified by this
manual or other documentation provided by Fluke Calibration,
the protection provided by the Calibrator may be impaired.
The 5080A Calibrator (the Product or the Calibrator) is a fully programmable
precision source of:
• DC voltage from 0 V to ±1020 V.
• AC voltage from 1 mV to 1020 V, with output from 45 Hz to 1 kHz.
• AC current from 29 μA to 20.5 A, with variable frequency limits.
• DC current from 0 A to ±20.5 A.
• Discrete resistance values from a short circuit to 190 MΩ.
Features of the Product include:
• Automatic meter error calculation.
•  and  keys that change the output value to pre-determined cardinal
values for various functions.
• Programmable entry limits that prevent entering invalid amounts.
• Simultaneous output of voltage and current, up to an equivalent of 20.9 kVA.
• Simultaneous output of two voltages.
• Variable phase signal output.
• EIA Standard RS-232 serial data interface to print, show, or transfer internally
stored calibration constants, and for remote control of the Product.

Fluke 5080A Specifications

General

Brand	Fluke
Model	5080A
Category	Test Equipment
Language	English