Fluke 96000 Series - Contact Fluke Calibration; Safety Information

96000 Series
Service Manual
1-2
Environmental and warm up conditions required for the performance test and
calibration adjustments are stated at the beginning of each of the respective
sections.
Unless otherwise directed, all connections are made via a Leveling Head of the
specified impedance.
Note
The Leveling Head is an integral part of the UUT functionality.
Repairs detailed in this manual are to the Modular-level only. For repair to a
deeper level, return the Product to Fluke Calibration or take the Product to a local
Fluke Calibration Service Center.
Contact Fluke Calibration
To contact Fluke Calibration, call one of the following telephone numbers:
• Technical Support USA: 1-877-355-3225
• Calibration/Repair USA: 1-877-355-3225
• Canada: 1-800-36-FLUKE (1-800-363-5853)
• Europe: +31-40-2675-200
• Japan: +81-3-6714-3114
• Singapore: +65-6799-5566
• China: +86-400-810-3435
• Brazil: +55-11-3759-7600
• Anywhere in the world: +1-425-446-6110
To see product information or download manuals and the latest manual
supplements, visit Fluke Calibration’s website at www.flukecal.com.
To register your product, visit http://flukecal.com/register-product.
Safety Information
This section addresses safety considerations and describes symbols that may
appear either in this manual or on the Instrument. A Warning identifies
conditions and procedures that are dangerous to the user. A Caution identifies
conditions and procedures that can cause damage to the Product or the
equipment under test.
 Warning
To prevent possible electrical shock, fire, or personal injury,
carefully read the information under General Safety Summary
before attempting to install, use, or service the Product.