Fluke 96000 Series - Low Voltage Transformer; Power Supply PCA

96000 Series
Service Manual
5-18
Low Voltage Transformer
To remove the low voltage transformer. See Figure 5-9.
1. Remove rear handles.
2. Remove the top and bottom covers.
3. Remove the internal shield.
4. Remove the RF Output PCA.
5. 96270A - Remove the 27 GHz Control PCA.
6. Remove the Rear Panel.
7. Remove the retaining bolt from the Low Voltage Transformer (13 mm
spanner) and lift out the transformer.
Power Supply PCA
To remove the Power Supply PCA. See Figure 5-10.
1. Remove rear handles.
2. Remove the top and bottom covers from the Product.
3. Remove the internal shield.
4. Remove the RF Output PCA.
5. 96270A - Remove the 27 GHz Control PCA.
6. Remove the Rear Panel Assembly.
7. Disconnect the two, 2-pin Molex connectors for the fans.
8. Disconnect the 60-pin ribbon cable using the connector ejectors.
9. Remove the six panhead screws that secure the PCA to the Product.
10. Lift the Power Supply PCA from the chassis.