96000 Series
Service Manual
5-16
Rear Panel Assemblies
The Rear Panel provides the hardware for mounting the Low Voltage
Transformer, the Interconnection PCA, and the Switch Mode Power Supply
Module. See Figure 5-9.
To remove the Rear Panel Assembly:
1. Remove rear handles.
2. Remove the top and bottom covers from the Product.
3. Remove the internal shield.
4. Remove the RF Output PCA.
5. 96270A - Remove the 27 GHz Control PCA.
6. Disconnect the four SMB connectors on the Synthesizer PCA.
7. Disconnect the 10-pin Molex connector from the Synthesizer PCA.
8. Turn the Product on its side to gain access to the rear panel Interconnections
PCA.
9. Disconnect the Interconnection PCA 34-pin IDE connector using the ejectors.
10. Return the Product to its initial position and remove the two countersunk
screws from each side of the rear panel.
11. Ease the rear panel away from the source to access and disconnect the two
Molex connectors from the SMPS Module and the Molex connector from the
low voltage transformer.
12. Pull the Rear Panel Assembly free of the chassis. Make sure the 10-pin
Molex connector and the four SMB connectors pass through the chassis cut
out without damage.
To Next Page
Loading...
