OptiView
TM
Series II
Getting Started Guide
6
Table 2. Other Available Accessories
Item Description Model/Part Number
OptiView Reporter
TM
OptiView Reporter
TM
allows you to generate reports on
the network you are connected to, based on criteria you
setup in the OptiView Reporter
TM
application. After the
OptiView Reporter
TM
is installed, the OptiView Reporter
TM
button is enabled in the OptiView Browser screen.
OPV-RPT
1578901
OptiView Protocol
Expert
TM
The Fluke Networks OptiView Protocol Expert
TM
application is a Windows based protocol analyzer for
network engineers, LAN administrators, and network
technicians who maintain LANs. The application allows
you to monitor and packet decode data on your local
network. The OptiView Protocol Expert
TM
application
supports OptiView
TM
analyzer packet capture files. This
product is intended to be used with the OptiView remote
user interface on a PC.
OPV-PE/PRO
1627440
OptiView
TM
Expert
Analysis Option
Adds expert analysis to the Fluke OptiView Integrated
Protocol Expert application on the analyzer, and to the
OptiView Protocol Expert PC application described
above. When you purchase this option, you are given a
key code that will need to be entered in the OptiView
Protocol Expert application’s Tools | Add New Plug-in
“Adding a Plug-in” screen.
OPVS2-EXPT
2139187
OptiView
Console
TM
The Fluke Networks OptiView Console
TM
application is a
Windows software tool for network engineers, LAN
administrators, and network technicians who maintain
LANs. The application allows you to monitor, map, and
troubleshoot LAN segments that could consist of servers,
routers, switches, printers, managed hubs, and clients
(hosts and other network devices).
OVC
2031945
DSP-FTK, Fiber
Optic Test Kit
The DSP-FTK Fiber Test Kit is used to measure the
optical power loss of fiber optic cables. The kit includes
an optical power meter (DSP-FOM) and an optical power
source (FOS-850/1300).
Together these instruments can verify the performance
of multimode fiber optic cable.
Simply connect the test kit's RJ-45 connector into the
analyzer's 10/100 BASE-TX port, go to the analyzer's
Cable Test screen and select the Fiber Test tab to
perform fiber measurements. Refer to the analyzer's Help
topic "Fiber Test" for setup procedures. The DSP-FTK
Fiber Test Kit is supplied in a hard carrying case with the
following:
• One (1) DSP-FOM power meter
• One (1) FOS-850/1300 power source
• One (1) ST-ST single mode-capable adapter
• Two (2) ST-ST jumper cables
• User documentation consisting of an instruction
sheet and registration card
DSP-FTK
615937
To Next Page
Loading...
Need help?
General
