To Next Page

To Previous Page

OptiView

Series II

Getting Started Guide

Do the touch targets seem to be off?

Try touching around the target to verify if the touch target calibration is off (this is

rare). If you suspect the touch target is off, select Setup | Display, press Touch

Screen Controller…, then Calibrate. You will be prompted to touch the display

at certain points to perform the calibration.

Are you connected to the network?

! Link light should be on solid green or amber if Link exists.

! Some activity on Transmit LED and/or Utilization LEDs should be seen.

! Go to Setup | Ethernet screen. An active interface should be indicated.

! Confirm that Cable Test passed. Try a different cable if necessary.

Does Cable Test pass?

A network connection can not be made if cable test does not pass. Look at the

Front Page screen Cable Test button and see if there is a red X or green check

mark in the button. A red X could indicate a faulty cable. If there is a red X, press

the Cable Test button and go to the Cable Test | Overview and Twisted-Pair

Detail screens to test the cable.

Does the battery charge state appear erratic or inconsistent, or is the battery not

consistently holding a normal charge?

Discharge the battery completely, then charge the battery for at least 5 hours.

Does the touch panel display (or Windows) not respond to input?

Press the On/Off button to place the analyzer in standby. Press the On/Off button

again to resume from standby.

If this does not correct the problem, try using a keyboard and/or mouse to

shutdown and restart Windows.

If this does not correct the problem, try pressing the Reset button (see Figure 28)

to reset Windows.

Note

A Windows Reset will not erase information collected on the data

acquisition card.

Fluke OptiView II Series User Manual

Questions and Answers: