Fluke PM6690 - Introduction; Measurement Functions; Frequency A, B, C; Frequency Burst A, B, C

Introduction
Only values with tolerances or limits are guar
-
anteed data. Values without tolerances are in
-
formative data, without guarantee.
Measurement
Functions
Refer to page 8-9 for uncertainty information.
Inputs A and B can be swapped in all modes
except Rise Time and Fall Time.
Display: All measurements are displayed with
a large main parameter value and smaller aux-
iliary parameter values (with less resolution).
Some measurements are only available as aux-
iliary parameters.
Frequency A, B, C
n
Range:
Input A: 0.001 Hz - 300 MHz
Input B: 0.001 Hz - 300 MHz
Input C: 100 MHz - 3 GHz
(PM6690/6__)
200 MHz - 8 GHz
(PM6690/7__)
Resolution: 12 digits/s
n
Display:
Main Parameter:
Aux. Parameters:
Frequency
V
max
,V
min
,V
p-p
Frequency Burst A, B, C
Frequency and PRF of repetitive burst signals
can be measured without external control sig
-
nal and with selectable start arming delay.
Functions: Frequency in burst (Hz)
PRF (Hz)
Number of cycles in burst
Range A, B, C: See Frequency A, B, C
Min. Burst
Duration: 40 ns (80 ns > 160 MHz)
Min. No. of Pulses
in Burst (Inp A, B):
(Inp C):
3 (6 above 160 MHz)
3 x prescaler factor
PRF Range
(see also
Inp C spec): 0.5 Hz - 1 MHz
Start Delay
Range: 10 ns - 2 s, resolution
10 ns
n Display:
Main Parameter:
Aux. Parameters:
Frequency in burst
PRF & number of cycles
in burst
Period A, B, C Average
n
Range:
Input A, B:
Input C (3 GHz):
(8 GHz):
Resolution:
3.3 ns - 1000 s
370 ps - 10 ns
125 ps - 5 ns
12 digits/s
n
Display:
Main Parameter:
Aux. Parameters:
Period
V
max
,V
min
,V
p-p
Specifications
8-2 Introduction