Fluke PM6690 - Trigger Indicators and Input Controls; Reference Oscillators and Acceptance Test

Rackmount Adapter
If you have ordered a 19-inch rack-mount kit
for your instrument, it has to be assembled af
-
ter delivery of the instrument. The rackmount
kit consists of the following:
–
2 brackets, (short, left; long, right)
–
4 screws, M5 x 8
–
4 screws, M6 x 8
WARNING: Do not perform any inter
-
nal service or adjustment of this
instrument unless you are qualified
to do so.
Before you remove the cover, dis
-
connect mains cord and wait for
one minute.
Capacitors inside the instrument
can hold their charge even if the in
-
strument has been separated from
all voltage sources.
n
Assembling the Rackmount Kit
–
Make sure the power cord is disconnected
from the instrument.
–
Turn the instrument upside down.
See Fig. 1-5.
–
Undo the two screws (A) and remove
them from the cover.
–
Remove the rear feet by undoing the two
screws (B).
–
Remove the four decorative plugs (C) that
cover the screw holes on the right and left
side of the front panel.
–
Grip the front panel and gently push at the
rear.
–
Pull the instrument out of the cover.
Unpacking 1-9
Preparation for Use
Fig. 1-3 Dimensions for rackmounting
hardware.
Fig. 1-4 Fitting the rack mount brackets
on the counter.
Fig. 1-5 Remove the screws and push the
counter out of the cover.