–
Remove the four feet from the cover.
Use a screwdriver as shown in the following
illustration or a pair of pliers to remove the
springs holding each foot, then push out the
feet.
–
Push the instrument back into the cover.
See Fig. 1-5.
–
Mount the two rear feet with the screws
(B) to the rear panel.
–
Put the two screws (A) back.
–
Fasten the brackets at the left and right
side with the screws included as illustrated
in Fig. 1-3.
–
Fasten the instrument in the rack via
screws in the four rack-mounting holes
The long bracket has an opening so that cables
for Input A, B, and C can be routed inside the
rack.
n
Reversing the Rackmount Kit
The instrument may also be mounted to the
right in the rack. To do so, swap the position
of the two brackets.
Preparation for Use
1-10 Unpacking
Fig. 1-6 Removing feet from the cover.
To Next Page
Loading...
