Main engine data page
● Status indicator: This is a useful indicator that you should
check before takeoff.
When the essential measurements are not in a safe area the
indicator shows “WARMUP” in red background; the
measurements taken in consideration are the oil pressure
(must be in green zone), the oil temperature (must be warmer
than “Clearance” parameter), the fuel pressure (must be in
green zone), the CAT (must be in green zone) and all the
CHTs (must be in green zone).
When all the measures becomes in its safe zone the indicator
change state to “READY” in green background, that
automatically disappear 30 seconds after take-off.
● Flight time: The flight timer starts automatically when the
engine meets or exceeds for 30 seconds the value set in the
“Flight” parameter (see chap.1.3.4, section “RPM setup menu”)
and it stops automatically when the engine is turned off (0000
RPM).
● Lap time: The lap time starts at the same time of the flight time
explained above but it can be reset during flight (see chap.2.3).
● ROTOR % (helicopter version only): Shows the rotor %, with
both graphical and numerical indication.
● Gearbox temperature (helicopter version only): with both
graphical and numerical indication in°Celsius or °Farhenheit,
depending on what unit of measure you have choosen in the
settings.
To Next Page
Loading...