21
EN
InstallingPowerTubebatterywithintegrated
coverfromabove
To insert the PowerTube batteryA2, place it on the
e-bike with its contacts on the lower holder A9. Tilt
it into the upper holder A7 until it reaches the limit
stopandaudiblyclicksin.Thebatteryisonlyxed
in the upper holder once this is done. Check that
thebatteryisttedsecurely.
Always remove the key A5 from the lock A6 once
you have fastened it shut. This will prevent the key
from falling out or the battery being removed by un
-
authorised third parties when your e-bike is parked.
To remove the PowerTube battery A2,switchito.
Unlock the lock with the key A5. Tilt the battery out
of the upper holder A7 and pull it out of the lower
holder A9.
Installing PowerTube battery with separate
coverfromabove
A21
A26
A25
A29
A27
To insert the PowerTube battery A21, place it on
the e-bike with its contacts on the lower holder
A29. Tilt it into the upper holder A27 until it reach-
es the limit stop and unlock the lock A26 so that
the battery
A21 can lock in place. The battery is
5.6 Insertingandremovingthe
battery
Alwaysswitchothebatterywheninser-
ting it into or removing it from the holder.
StandardAkku
To insert the standard battery A8, place it on the
e-bike with its contacts on the lower holder A9
(the battery can be tilted by up to 7° relative to
the frame). Tilt it into the upper holder A7 until it
reaches the limit stop. Check that the battery is
ttedsecurely.
Always fasten the battery with lock A6, otherwise
the lock will open and the battery may fall out of
the holder.
Always remove the key A5 from the lock A6 once
you have fastened it shut. This will prevent the
key from falling out or the battery being removed
by unauthorised third parties when your e-bike is
parked.
To remove the standard battery A8, switch it o
and unlock the lock with the key A5. Tilt the battery
out of the upper holder A7 and pull it out of the
lower holderA9.
A5
A6
A7
7°
A8
A9
To Next Page
Loading...
