Flyer Gotour 6 - 12. Adjusting Bike to Rider

33
EN
Completely close the quick release lever (4).
The Speedlifter quick release lever must
be completely closed during the ride, just
like any other quick release fastener. It
must also be ensured that the unlocking
bolt is latched in the front hole. Never ad
-
just the handlebars while riding.
Read the instructions of the component
manufacturer and for more information
visit: www.speedlifter.com.
Adjustingthestem
For detailed information, please read the
instructions supplied by the manufactur-
er. Only allow FLYER specialists to work
on your handlebars and stem.
The
following stem types are installed on FLYER:
A-Head stem
Adjustablestem
The incline of the stem can be adjusted to your
requirements. The lateral fastening screw must
be loosened and retightened with the correct
fastening torque after adjustment (see the sepa
-
rate “Technical Data” operating instructions doc-
ument).
4
Adjustable stem
Fastening screw
Lift the unlocking bolt (2).
The handlebars can now be turned sideways (3).
The bolt automatically latches in the 90-degree
positon (4). Completely close the quick release
lever so that the handlebars are safely fastened.
Turning back the handlebars: Lift the unlocking bolt (1).
Then turn the handlebars back to the driving posi-
tion (2). The bolt must be re-latched (3).
2
4
3
90°
1
3
2
90°