FMS Fox - During Operation Safety

37
• Before commissioning, check the trim lever settings at the transmitter for direction control and adjust them if
required.
• Always check the correct and secure position of the propeller before operation.
• Make sure that no objects, clothes or body parts are in the range or the suction area of the rotors while they are
rotating.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment depends comple-
tely on your responsible use of the model.
• Improper operation can cause serious damage to people and property! Therefore make sure to keep a sufciently
safe distance to persons, animals or objects during operation.
• Select a suitable ight room to operate your model. We recommend choosing a windstill or low-wind day for your
rst ights.
• Only y your model if your ability to react is unlimited. The inuence of tiredness, alcohol or medication can cause
incorrect responses.
• Do not y directly towards audience or yourself.
• Motor, ight controller and ight battery may heat up during operation of the model. For this reason, wait for 5 to
10 minutes before recharging or replacing the ight battery. The drive motor must have cooled down to ambient
temperature.
• As long as the model is in operation you must always leave the transmitter switched on. After landing, always
disconnect the ight battery from the model rst. Only then may the transmitter be switched off.
• In case of defect or malfunction, remove the cause of the interference before starting your model again.
• Never expose your model or the transmitter to direct sunlight or excessive heat for an extended period of time.
• After use, the ight battery must be disconnected from the model and the transmitter switched off.