How to fix FOR-A MFR when there is no image output?
If you're experiencing no image output on your FOR-A Switch, first ensure that video signals are being input to the video input connectors. Check that the cables are correctly connected for the signal inputs. Finally, verify that the crosspoint is set properly.
What to do if there is no image output from FOR-A Network Router?
If you're experiencing no image output on your FOR-A Network Router, first ensure that video signals are being input to the video input connectors. Next, verify that the cables are properly connected for these signal inputs. Finally, check that the crosspoint settings are correct.
Why I am unable to control FOR-A Network Router using the remote control panel?
If you can't control your FOR-A Network Router using the remote control panel, start by ensuring the LAN cable is properly connected. Then, check the RU Info page in the Web-based Control to see if it indicates 'NG' for any items. If 'NG' is indicated for Voltage, contact your FOR-A agent. For other items, consult the Web-based Control Operation Manual for details.
To Next Page
General
