Fostex MR-8CD - Page 115

115
MR-8HD/CD Owner’s Manual (Part editing)
10) Press the [MENU/ENTER] knob.
The display now returns to the part edit menu
screen, where “Copy-Paste Part
” is highlighted.
11) Press the [STOP] key to exit the menu mode.
6) Rotate the [MENU/ENTER] knob to select "Source
Track = *", and press the [MENU/ENTER] knob.
The display now shows the screen for
selecting the copy source track(s). You can
select the copy source track(s) by rotating the
[MENU/ENTER] knob. The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
7) Rotate the [MENU/ENTER] knob to select the source
track(s) to be copied, and press the [MENU/ENTER]
knob.
You can select the destination track(s) by
rotating the [MENU/ENTER] knob.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
<Note>: You cannot select the same track(s)
for the copy source and destination.
<Note>: If you are not satisfied with the re-
sult, press the [
UNDO/REDO ] key to undo the
operation (see page 111).
5) Rotate the [MENU/ENTER] knob to select "Copy-
PastePart
", and press the [MENU/ENTER] knob.
The display now shows the screen for
selecting the source track(s) and destination
track(s) of copy/paste. "
Back" is initially
highlighted.
9) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" at the bottom of the screen,
then press the [MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8HD/
CD completes the copy/paste operation.
To cancel the copy/paste operation, move the
cursor to "[CANCEL]" at the bottom of the
screen, and press the [MENU/ENTER] knob.
8) Rotate the [MENU/ENTER] knob to select the
destination track(s), and press the [MENU/ENTER]
knob.
The display returns to the previous screen.
Flashing
Flashing
Flashing
Flashing