117
MR-8HD/CD Owner’s Manual (Part editing)
6) Rotate the [MENU/ENTER] knob to select
"Copy Track
", and press the [MENU/ENTER] knob.
The display now shows the screen for selecting
the copy source track(s).
You can select the copy source track(s) by
rotating the [MENU/ENTER] knob.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
8) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" at the bottom of the screen,
then press the [MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8HD/
CD completes the part copy operation.
To cancel the part copy operation, move the
cursor to "[CANCEL]" at the bottom of the
screen, and press the [MENU/ENTER] knob.
The following procedure is assumed that the
LOCATE A point, the paste destination, is set
Pasting clipboard data
9) Press the [MENU/ENTER] knob.
The display now returns to the part edit menu
screen, where “Copy Part
” is highlighted.
The procedure example below shows how
to paste the copied part data on the
clipboard to the LOCATE A point of the
selected track.
7) Rotate the [MENU/ENTER] knob to select the track(s)
to be copied, and press the [MENU/ENTER] knob.
The display returns to the previous screen.
1) Rotate the [MENU/ENTER] knob to select
"Paste Part >", and press the [MENU/ENTER] knob.
The display now shows the screen for
selecting the paste destination track(s).
"
Back" is initially highlighted .
2) Rotate the [MENU/ENTER] knob to select
"Paste Track = *", and press the [MENU/ENTER]
knob.
You can now select the desired paste destination
track(s) by rotating the [MENU/ENTER] knob.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
Flashing
Flashing
To Next Page
Loading...
