Fostex MR-8CD - Page 118

118
MR-8HD/CD Owner’s Manual (Part editing)
5) Press the [MENU/ENTER] knob.
The display now returns to the part edit menu
screen, where “Paste Part
” is highlighted.
6) Press the [STOP] key to exit the menu mode.
<Note>: If you are going to carry out the
paste operation when no data is pasted on
the clipboard, the error message (“ Clipboard
Empty!
) is shown on the display and the MR-
8HD/CD does not accept the operation.
Press the [
STOP ] key to exit the menu mode
and copy the desired data to the clipboard
before carrying out the paste operation.
<Note>: If you are not satisfied with the re-
sult, press the [
UNDO/REDO ] key to undo the
operation (see page 111).
3) Rotate the [MENU/ENTER] knob to select the
paste destination track(s), and press the
[MENU/ENTER] knob.
The display returns to the previous screen.
4) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8HD/
CD completes the paste operation.
If you want to cancel the part paste operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] knob.
Flashing
Flashing