108
MR-8HD/CD Owner’s Manual (Track editing)
You can exchange whole data (from ABS ZERO to REC END) between the desired track(s).
<Note>:
You cannot exchange track data of a song
protected. Release the protection before exchang-
ing track data.
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
ABS ZERO REC END
<Note>:
If you want to cancel the move opera-
tion, move the cursor to "
[CANCEL]
" on the
screen, and press the [
MENU/ENTER
] knob.
9) Press the [MENU/ENTER] knob.
The display now returns to the track edit menu
screen, where “Move Track
” is highlighted.
10) Press the [STOP] key to exit the menu mode.
<Note>:
If a destination track has recorded
data, moving data overwrites the previous
data.
<Note>:
If you are not satisfied with the re-
sult, press the [
UNDO/REDO
] key to undo the
operation (see page 103).
<Note>:
You cannot select the same track(s)
for the move source and destination.
You can select the same number of tracks as
the move source track(s). For example, if you
select a mono track for the move source, you
can only select a mono for the move destina-
tion.
1) Load the song you want to edit.
2) While the recorder is stopped, press the
[MENU/ENTER] knob to enter the menu mode.
The display now shows the first page of the
menu selection screen, where "
Back" is
highlighted initially (selecting "
Back"
returns to the previous screen).
3) Rotate the [MENU/ENTER] knob to select
"Track Edit ", and press the [MENU/ENTER] knob.
The display now shows the track edit menu
screen, where "
Back" is highlighted.
8) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8HD/
CD completes the move operation.
7) Rotate the [MENU/ENTER] knob to select
destination track(s), and press the
[MENU/ENTER] knob.
“Dest. Track = *” is now highlighted on the screen.
Exchanging whole track data
Flashing
To Next Page
Loading...
